Service
Gas Line Installation
Request a quote for gas line installation in Utah for stoves, fireplaces, dryers, grills, fire pits, generators, commercial projects, and more.
Use this free calculator to total the input ratings of existing and planned gas appliances. It creates a simple connected-load summary you can copy or share with an HVAC contractor, plumber, generator installer, fireplace dealer, appliance installer, or gas piping professional.
This is not a gas pipe sizing calculator. The result does not confirm that an existing meter, regulator, service, or gas line can support the load. Use the BTU ratings from the equipment nameplate or manufacturer documentation whenever possible.
For planned and non-emergency gas line work. There's no charge to send a request.
Add each gas appliance and enter its rated maximum input in BTU/hr. Mark whether it is already connected or planned.
BTU totals are arithmetic only. A qualified professional should verify actual connected load, diversity rules where applicable, meter/service capacity, regulator requirements, pipe material, developed length, allowable pressure drop, and local code requirements before modifying a gas system.
Gas appliances are commonly labeled with a maximum input rating in BTU per hour. Adding those ratings provides a useful project summary of the appliance demand entered, but the arithmetic total by itself does not determine gas pipe size or confirm system capacity.
Use the equipment nameplate, installation manual, specification sheet, or manufacturer documentation. Avoid guessing from the appliance category because different furnaces, water heaters, generators, fireplaces, ranges, and commercial appliances can have very different input ratings.
Gas pipe sizing depends on more than total BTU. A professional may need to evaluate the fuel-gas system design, supply pressure, allowable pressure drop, pipe material, developed length, fittings, equipment requirements, meter or service capacity, regulators, and applicable codes. For that reason, this calculator stops at a load summary rather than recommending a pipe diameter.
Browse the full gas line planning tools collection. Once you have the appliance ratings, add the route, location, approximate distance, timing, and project notes with the Gas Line Project Brief Generator. You can also use the Utah Gas Line Cost Estimator for early budgeting.
Depending on the property, the connected gas load may include furnaces, boilers, tank or tankless water heaters, ranges, cooktops, ovens, dryers, fireplaces, generators, grills, fire pits, pool or spa heaters, and commercial equipment.
No. Total appliance input is only one part of gas-system design. Pipe sizing also depends on factors such as pressure, developed length, material, system layout, equipment requirements, and the applicable code methodology.
For a connected gas-load summary, use the appliance’s rated gas input shown by the manufacturer rather than heating output.
Yes. Mark existing appliances as existing and the proposed equipment as planned. The tool will show the entered current load, added load, and combined load so you can share those figures during a professional capacity evaluation.
For a non-emergency Utah project, provide the equipment model, rated input, property location, likely route, and approximate line distance when requesting a quote.
The request form is just below.
Permits and inspections. Gas piping work usually needs a permit from your city or county building department. That includes new lines, extensions, and many appliance installations and replacements. New piping is pressure-tested and inspected before gas is turned on. Requirements vary by city. Ask the provider who will get the permit and schedule inspections, and get the scope and price in writing before work starts.